Trains stopped at junction

[DoughnutSpanker]

Hey guys.

I'm doing a scenario with AutoMod.
I have this huge stresspoint at my steel mill and I have a problem.

pic attached.

The Orange track branches off from the green/orange track and goes to its station (in pic). I don't have a problem with that though.

My coal and Iron Ore train freeze on the tracks.

FYI there is a train in 5 and 1 loading steel. 5 uses orange/green track to deliver, 1 uses purple.

Please help!

[Illegal_Alien]

On track 3 coal/ore train cant get back on red track.

[DoughnutSpanker]

On track 3 coal/ore train cant get back on red track.

Yes, sorry I didn't make this clear enough.

On this map the coal and ore mines are close to each other. EX: {coal and ore} then somewhere else {coal and ore}

2 and 3 go to one set of coal/ore mines
4 and 5 (and 6) another set of coal/ore mines

So 3 doesn't need to get on 4,5,or 6.

Thanks for the reply.

[DoughnutSpanker]

Bumpity Bump

[Plastikman]

if you look at what you built real close.

the if the red train pulls into platform 4, it can only exit on the green/orange track.

there is no crossover to get to the red.

[DoughnutSpanker]

if you look at what you built real close.

the if the red train pulls into platform 4, it can only exit on the green/orange track.

there is no crossover to get to the red.

Thanks, I fixed the track.

But the train is still sitting there.

[uktrackbuilder_loco]

Right going to be honest DS that is not an approach layout on roads 4 and 5 I'd use

I would cut your out road from 4/5 aka the orange marked one back
Use the former part of that to take your in road aka the green marked one to 4 and 5

Then send all traffic out on your new 5 putting in a burrowing junction aka a dive under to take trains from that to the other outward line. I've redone your screen shot as i would have laid out the junction