Take a look at this

PeteB · Post by **PeteB** » 13 Jan 2006 20:03

Here's a couple of screenshots showing OpenTTD with the U.S Set, plus some of the Temperate set. Seems to be very stable.

Pete

jvassie · Post by **jvassie** » 13 Jan 2006 20:26

Except some of the graphics arent right.... ie the Re460

PeteB · Post by **PeteB** » 13 Jan 2006 21:24

jamesvassie wrote:Except some of the graphics arent right.... ie the Re460

Yes, there's also an issue with the Temperate TGV in that it just shows standard carriage and Mail van not the built in ones. I did have the cargoset running as well but it screwed up some of the cargoes. Also the Sunset loco from the US Set doesn't work, it has STOP on top of the engines. I've been running from 1950 without a single crash, so far I have 450 or so trains plus 150 road vehicles.

Pete

White Rabbit · Post by **White Rabbit** » 14 Jan 2006 13:46

Awesome. It's nice that this is my 500th post.
One question: what build are you using?

sd70 · Post by **sd70** » 14 Jan 2006 14:30

Pete, how did you get the US Set to work on Open TTD? I've been trying to get it to work for months with no luck. Could you please email me a copy of your cfg file or post exactly what you did along with the build version? Thanks in advance,

BNSF Engineer

PeteB · Post by **PeteB** » 14 Jan 2006 20:17

White Rabbit wrote:Awesome. It's nice that this is my 500th post.
One question: what build are you using?

I'm using 3345IA, I think thats the last integrated build.

Pete

ISA · Post by **ISA** » 14 Jan 2006 20:24

PeteB pls cna you post this usset here?:roll: Pls

thank you

Born Acorn · Post by **Born Acorn** » 14 Jan 2006 20:29

Looking yourself wouldn't be too hard either.

http://www.as-st.com/ttd/newusa/index.html

ISA · Post by **ISA** » 14 Jan 2006 20:31

Born Acorn wrote:Looking yourself wouldn't be too hard either.

http://www.as-st.com/ttd/newusa/index.html

Im laaaaaazzzzzzyyyyy!

PeteB · Post by **PeteB** » 14 Jan 2006 20:35

sd70 wrote:Pete, how did you get the US Set to work on Open TTD? I've been trying to get it to work for months with no luck. Could you please email me a copy of your cfg file or post exactly what you did along with the build version? Thanks in advance,

BNSF Engineer

It would seem that the US Set I'm using is an old version, it's showing a date of 02/12/2005 but I'm pretty sure that was when I downloaded it. I'll send you the file shortly. Regarding the cfg, the only way it would work properly is to make it the first entry in the newgrf configuration. See my previous post for the version of OTTD I'm using.

Cheers,

Pete

PeteB · Post by **PeteB** » 14 Jan 2006 20:38

Born Acorn wrote:Looking yourself wouldn't be too hard either.

http://www.as-st.com/ttd/newusa/index.html

Its not that version, I've no idea of the history of The US Set but this file is much smaller than the latest version, a mere 600kb. I don't remember where I found it but I can E-Mail it to anyone who requests it.

Pete

ISA · Post by **ISA** » 14 Jan 2006 20:43

send it to email

Thank you !

PeteB · Post by **PeteB** » 14 Jan 2006 21:13

ISA wrote:send it to email biggguy@hot.ee

Thank you !

There's a problem with that E-Mail

----- The following addresses had permanent fatal errors -----
<biggguy@hot.ee>

----- Transcript of session follows -----
... while talking to mail.hot.ee.:
>>> RCPT To:<biggguy@hot.ee>
<<< 550 <biggguy@hot.ee>: Recipient address rejected: User unknown in relay recipient table
550 <biggguy@hot.ee>... User unknown
>>> RSET
<<< 421 Relayhost2.neti.ee Error: too many errors

Pete

PeteB · Post by **PeteB** » 14 Jan 2006 21:18

Here's the newgrf part of my config file.

[newgrf]
ussetw.grf
tempsetw.grf
TGV-Atlantique.grf
ttrs2w.grf
newtown_415.grf
newbridgesw.grf

Pete

Born Acorn · Post by **Born Acorn** » 15 Jan 2006 00:08

If you use the latest nightly, I would recommend newstations by Michael Blunck. The waypoints now work.

ISA · Post by **ISA** » 15 Jan 2006 01:48

PeteB wrote:
ISA wrote:send it to email

Thank you !
There's a problem with that E-Mail

Pete

Sry my bad, with two g-s

Once again bigguy@hot.ee

Gedemon · Post by **Gedemon** » 15 Jan 2006 11:58

Born Acorn wrote:If you use the latest nightly, I would recommend newstations by Michael Blunck. The waypoints now work.

didn't they work since a long time ? there's a modern waypoint working too (sorry don't remember the author name, file is "modern_waypoint_183.grf"). It have a maglev style but it fit nicely with normal rails...

btw does anyone got feedback on progress on large newstation ? I don't know where to find the files on peter's new website

edit : my usset still doesn't work with latest snv until I uncomment a line in InitializeGRFSpecial as commented by pasky, allowing set who needs electrified railway to be loaded anyway. (I'm also able to use a japanset with this hack)

PeteB · Post by **PeteB** » 15 Jan 2006 19:09

ISA wrote:
PeteB wrote:
ISA wrote:send it to email

Thank you !
There's a problem with that E-Mail

Pete

Sry my bad, with two g-s

Once again bigguy@hot.ee

Done!!

Pete

ISA · Post by **ISA** » 16 Jan 2006 02:21

PeteB wrote: Done!!
Pete

Thx man! I mean it

Gedemon · Post by **Gedemon** » 16 Jan 2006 13:02

strange : since I uncommented the line allowing openttd to fake electric railways "on", it seems that I don't have anymore the probleme of "STOP on top of the engines" on dbsetXL

well... anyway... that's fine...

Transport Tycoon Forums

Take a look at this

Take a look at this

Who is online