747

[Ducky]

Does anyone know if there are any sets for the 747 series? The -100, -400. -F types? If not how difficult do you think it would be to make? It's all the same graphics as the stock 747, just changing the parameters i think

Duck

[metalangel]

It wouldn't be hard to make, really... a few minutes in Locotool fiddling the capacities and names and you could create the whole range.

[Ducky]

Cool, I'll give it a go and see what I can do.

Duck

[dave61]

Does anyone know if there are any sets for the 747 series? The -100, -400. -F types? If not how difficult do you think it would be to make? It's all the same graphics as the stock 747, just changing the parameters i think

Duck

Rivet counters might wish to alter the appearance too: shorter upper deck on the -100, winglets on the -400, etc. Personally, I think life's too short. If these things matter to you buy MSFS.

[Ducky]

Ok, I'm done (I think). Does anyone want to try them out? I'm busy testing them, once done shall I upload for everyone?

Duck

P.S. I'm asking because I'm not sure whether someone else has already done/in progress and as a newbie i don't want to trample on anyones toes

[TheGrew]

The 747SP is very small So you would need different graphics.

[Ducky]

Yeah, I noticed that For Now, I'm just using the same graphics for all the 747 Series. If someone would like to edit them then that would be great. It's very little actual editing, jsut stretching the bulge slightly for the -300 and -400 and maybe making some indication of the nose cone hinge for the -400F All six are done (747-100, 747-200, 747-300, 747-400, 747-400F and 747-SP). I'll upload them to a WIP thread.

Duck

[thompson_fan]

i'll test them for u if u want