Advice on signals

[ahtom133]

there are 2 kinds signals one is one way and a block how to use this two signals ??? need help ASAP got a lot of trains and waste a lot of time < sorry for my english. is there any new signals ?

[Zakos]

The one-way signals are for directing traffic in a specific direction. By directing trains as shown below, you can have a much more efficient rail service.

Here I have four trains running on this one line making much more money than just one.

Screenshot1.png (186.39 KiB) Viewed 23009 times

Notice that the trains are traveling in both directions like a highway.

Screenshot2.png (155.78 KiB) Viewed 23009 times

Two-way signals can direct traffic in two directions, but they're usually best for complex stations like this:

Screenshot3.png (277.84 KiB) Viewed 23009 times

______________________

Normally I would give you a link to the signals guide on AMI Trains, but it is currently unavailable.

[PhiliThunder]

With one way signals you can also have more than two trains

[ahtom133]

Well sometime i use both signals. And i have not just use 1 or 5 train running < the rail are very long it station are very big some like 3 to 5 as big as i can make by use the signals is waste a lot of time and i have to make many crossover points < there is 4 track 2 by 2 in and out here i have to make big crossover and put so many signals and this why all my 10 to 15 trains are be stop and wait there. what to do ?

[Greyfox]

@ahtom133: Are you sure you don't have to many trains on one route? Can you post some screenshots?