[Mac OS X] Problem Compiling OpenTTD

[GiveItATry]

Hello Together,

i tried to compile the last branch in repository, using the guide form wiki, on Mac OS X 10.6.6. I followed the steps, first installing the libraries and getting the last branch. But if i try to run configure the script can not find the lzma library. I got the following Error:

Code: Select all

checking liblzma... not found
WARNING: lzma was not detected or disabled
...

Can you give me any help with this?

Big Thanks!

P.S. Searched the net and the board for an solution, but without result!

(Sorry for my bad English :/)

[Arie-]

liblzma sounds like a library: lib - lzma. Sure you have this one installed?

[planetmaker]

Can you give me any help with this?

Follow the advice it gives you and install the library - just as Arie- says.

In general it's a good idea to have all development libraries at hand which are mentioned on http://www.openttd.org/en/development and you surely have also not looked at the most obvious place for advice, our wiki: http://wiki.openttd.org/Compiling_on_Mac

[GiveItATry]

As i allready wrote I first installed the libraries! I used Mac Ports to do this. If I check Mac Ports he sais me liblzma is installed!

Code: Select all

The following ports are currently installed:
  expat @2.0.1_1 (active)
  fontconfig @2.8.0_0 (active)
  freetype @2.4.4_0 (active)
  gettext @0.18.1.1_2 (active)
  gperf @3.0.4_0 (active)
  icu @4.6_0 (active)
  libiconv @1.13.1_0 (active)
  liblzma @5.0.0_0 (active)
  libpng @1.2.44_0 (active)
  lzma @4.63_0 (active)
  lzo2 @2.03_2 (active)
  ncurses @5.7_1 (active)
  ncursesw @5.7_1 (active)
  xz @5.0.0_0 (active)
  zlib @1.2.5_0
  zlib @1.2.5_0+universal (active)

I followed the wiki Guide step by step :/.

[Wintersoldier]

Have you tried compiling lib lzma manually?