Page 1 of 1

Problem with Newgrf

Posted: 21 Nov 2008 23:51
by B-b0y
Ok, I don't know what happened here. Can someone tell me what the cause of this is and how to solve it?

Re: Problem with Newgrf

Posted: 22 Nov 2008 00:04
by Rubidium
Start by reading the readme of that NewGRF. It'll state that the vehicle may only be of a few specific lengths.
You should, by the way, be happy that it shows question marks because a long time ago it would've just crashed OpenTTD.

Re: Problem with Newgrf

Posted: 22 Nov 2008 12:17
by XeryusTC
You could have noticed that the wagons say "MORE" when you have an incorrect length :roll:

Re: Problem with Newgrf

Posted: 22 Nov 2008 12:18
by PhilSophus
B-b0y wrote:Ok, I don't know what happened here. Can someone tell me what the cause of this is and how to solve it?
I guess, this is the ICE3 from DBSetXL, right? Actually, the graphics already says what is wrong: It wants more wagons (or less). IIRC, the ICE3 only allows 8 and 16 wagons, but I'm not totally sure on the numbers.

Re: Problem with Newgrf

Posted: 22 Nov 2008 12:56
by skycargo
I have the same problem,thats why i don't use the set. :?

Re: Problem with Newgrf

Posted: 22 Nov 2008 18:13
by Badger
skycargo wrote:I have the same problem,thats why i don't use the set. :?
No, you're just a proven idiot.

Re: Problem with Newgrf

Posted: 22 Nov 2008 18:52
by B-b0y
XeryusTC wrote:You could have noticed that the wagons say "MORE" when you have an incorrect length :roll:
well, I didnt make these myself. They were brought into existence by autoreplace, and the first ICE did work so the possibilty of incorrect length didnt occur to me.