Page 1 of 1
Problems with my junction
Posted: 10 Sep 2004 17:12
by tompagenet
Okay - this one perplexes me - why does the train that is in the middle of the picture just go straigh ahead towards a filled platform rather than to the useful empty platform?
Any help appreciated - thanks, Tom
Posted: 10 Sep 2004 18:24
by Steve
Unfortunately there seems to be problems in that design. There is an open platform, so the train gets let through the signal, but there are too many turns to get to the right platform so it just goes forwards.
It can be fixed with some different track layouts, or just get rid of that 4th platform and use the other 3. They have no problems getting out again.
I'm collecting some successful junction designs together and will make a new section for them.
Posted: 11 Sep 2004 08:55
by squishycube
Steve, you propose exactly this junction on your lomodepot as a terminus design.I think you'd better remove it.
Posted: 11 Sep 2004 09:33
by tompagenet
So is there any way of having a four platform terminus design? If not, this is something of a major flaw! I've just looked at the image and there are only two curves to get to the free platform!
Thanks, Tom
Re: Problems with my junction
Posted: 11 Sep 2004 13:03
by LuPoM
tompagenet wrote:Okay - this one perplexes me - why does the train that is in the middle of the picture just go straigh ahead towards a filled platform rather than to the useful empty platform?
Any help appreciated - thanks, Tom
use my station design and it will works perfectly
here is the "explaining" screen... sorry for the mess, I did it in a hurry and will do it again later...
