Moderator: OpenTTD Developers
I am trying to understand how path signals work. I have made this test scenario (see in attachment).
- top train has two stations - Transfer <--> West
- bottom train has two stations - West <--> Halt
- current order of both trains is goto West
Question is, why both trains are waiting for free path? As far as I understood, each train should reserve highlighted (red & blue) piece of track and they should not interfere.
This only happens, when the middle trainstaion is connected from back side too (so it creates loop). If I remove the green highglighted connector, they don't wait for pree path and work normally. But the manual says, that trains should only reserve the path to the safe stopping point, which is the station. They should not care about what's after the station.
Can you help me uderstand this situation? Thanks
- (1.36 MiB) Not downloaded yet
If you want to better understand how path signals work, there is a useful feature to show them.
In the case you showed pathfinder without any signals restrictions, he also tried to search for the rest of the route, i.e. back to the first station (orange line), and he did so, but could not let the train start because the road to the first station was already taken, by some train - in this case the same train. It was enough to put up a signal to break the search and let the train move. Interestingly, after stopping at the second station, pathfinder will search the paths again and send the train the same way it came (unless the option to prohibit U-turns at stations was not enabled).
- reserved path.PNG
- (285.31 KiB) Not downloaded yet
Another screenshot, you will see a few trains on the crossing lines, they were allowed into this section because they could find a safe path to the next signal, if there is not a safe path the signals would not allow them onto that section (remain red)
I have included a save as an example, without any GRF's and three trains.
Users browsing this forum: No registered users and 5 guests